- Part size (listed below)
- MDPE coupling to female brassware
- For use ABOVE OR BELOW GROUND
- Can be used with hot or cold water
- True push fit, no wrenches required
- Reduces labour time
- Rated at 30bar pressure
- Pull and snatch tested to over 200kg
- No flow restriction
- No liner required
Our original PUSH-LOC was developed to solve the problem of Joining MDPE to copper. The MDPE end is FOR 20 to 25mm. The copper compression end is for use with 15 to 25mm copper and exceeds current water regulations for use on hot and cold water up to 80c. PUSH-LOC will withstand end loads up to 200kg and is pressure tested to 30bar and can withstand temperatures ranging from -35c to 250c. D4003 PUSH-LOC 25mm push-fit fitting Stop End for use with MDPE. D4004 PUSH-LOC is a 25mm push-fit fitting to solve the problem of Joining MDPE to MDPE. We use dual O ring technology as a positive pipe stop that allows for any MDPE manufacturing tolerance and supports side loading. We then use a specially designed grip ring that allows a true PUSH-FIT, grips MDPE without any pipe distortion or restricted flow. For help with ascertaining the correct PUSH-LOC you require please visit our recourses link to find our installation pipe chart.
See our Push-Loc Range..
Are you a distributor? - get in touch, we’re here to help